Conrad Electronic WH1070 Notice D'emploi page 67

1. When you briefly press the SET button while the base station is in normal display
mode, it changes to the configuration mode for the display.
The display section for the outdoor temperature blinks.
2. With the +/
- button or MIN/MAX button, you decide which value will be dis-
played from now on. You can select between the displays:
• „TEMP" = outdoor temperature
• „WIND CHILL" = windchill temperature
• „DEW POINT" = dew point temperature
3. Briefly press the SET button to confirm the selection and change to the next set-
ting. The display section for the air pressure blinks.
4. With the +/ - button or MIN/MAX button, you select between the displays:
• „rel" = relative air pressure
• „abs" = absolute air pressure
5. Briefly press the SET button to confirm the selection and change to the next set-
ting. The display section for the wind speed blinks.
6. With the +/ - button or MIN/MAX button, you select between the displays:
Wind speed
• „Gust" = wind gust speed
7. Briefly press the SET button to confirm the selection and change to the next set-
ting. The display section for the rain quantity blinks.
8. With the +/ - button or MIN/MAX button, you select between the displays:
• „1h" = rain quantity in 1 hour
• „24h" = rain quantity in 24 hours
• „week" = rain quantity within 1 week
• „month" = rain quantity within 1 month
• „Total" = total rain quantity
Manual reset of the rain quantity display
While the total rain quantity value blinks (value and „TOTAL"), press and
hold the SET button for approx. 2 seconds. The rain quantity values are
deleted.
9. Briefly press SET to confirm your selection and to quit the setting mode.
All manuals and user guides at all-guides.com
67