Technical Specifications; Charging The Ftd - ADEUNIS sigfox RC2 Guide Utilisateur

FIELD TEST DEVICE sigfox RC2 - Guide utilisateur / User guide version V1.0.0

1.3. Technical specifications

Radio
Communication
Network area
Supply
Connector
Battery
Opérational
Device configuration
Serial rate
Parity
Amount of data
Stop bit
Functioning temperature

1.4. Charging the FTD

The device is equipped with a rechargeable battery. Once the device has been connected to a USB charger or the USB socket of a computer, it
will start to charge automatically; even if the ON/OFF communicator is set to OFF (this functions in exactly the same way as a mobile phone).
The device can be used while it is charging. During charging, the charge indicator will be red. When the device is fully charged, the indicator will
turn green.
Figure 1 : Device charging
If the battery is completely empty, it will be necessary to recharge the device for 6 hours in order for it to be fully charged.
All manuals and user guides at all-guides.com
sigfox protocol and DBPSK sigfox
RC2
Micro-USB - 5V - 500mA
Lithium-Ion Polymer 3.7V 2Ah 7.4Wh
Via AT commands
(see relevant chapter to find a full list of available AT commands)
115.2 kbps
None
8
1
-30°C / +70°C
Figure 2 : Device is fully charged
FR
EN
Page 31 of 44