Technical Specifications; Charging The Ftd - ADEUNIS LoRaWAN Europe EU863 Guide Utilisateur

FIELD TEST DEVICE - LoRaWAN Europe - Guide utilisateur / User guide version V1.2.3

1.3. Technical specifications

Radio
Communication
LoRaWan Specification compliant
Radio Rate
RF Power
Sensitivity
Range (Open)
Standards met
Network area
Frequency
Supply
Connector
Battery
Operational
Device configuration
Serial rate
Parity
Amount of data
Stop bit
Functioning temperature

1.4. Charging the FTD

The device is equipped with a rechargeable battery. Once the device has been connected to a USB charger or the USB socket of a computer, it will
start to charge automatically; even if the ON/OFF communicator is set to OFF (this functions in exactly the same way as a mobile phone). The device
can be used while it is charging. During charging, the charge indicator will be red. When the device is fully charged, the indicator will turn green.
Figure 1 : Device charging
If the battery is completely empty, it will be necessary to recharge the device for 6 hours in order for it to be fully charged.
LoRaWAN protocol & LoRa Modulation
V1.0.1
Variable (SF12/125kHz (~183 bps) to FSK (~50kbps)
14dBm (25mW)
down to -140 dBm in SF12/CR4
Up to 15km
EN 300-220, EN 301-489, EN 60950
EU863-870
ISM band 865-870MHz
Micro-USB - 5V - 500mA
Lithium-Ion Polymer 3.7V 2Ah 7.4Wh
Via AT commands
(see relevant chapter to find a full list of available AT commands)
115.2 kbps
None
8
1
-30°C / +70°C
Figure 2 : Device is fully charged
FR
EN
Page 37 of 55