Environmental Recommendations - ADEUNIS sigfox RC2 Guide Utilisateur

FIELD TEST DEVICE sigfox RC2 - Guide utilisateur / User guide version V1.0.0

ENVIRONMENTAL RECOMMENDATIONS

All superfl uous packaging materials have been eliminated. We have done everything possible to make it easy to
separate the packaging into three types of materials: cardboard (box), expanded polystyrene (fi ller material)
and polyethylene (packets, foam protective sheets). Your device is composed of materials that can be recycled
and reused if it is dismantled by a specialist company. Please observe local regulations concerning the manner in
which waste packaging material, used batteries and your obsolete equipment are disposed of.
FR
WARNINGS
Valid for products indicated in the declaration of conformity
Read the instructions in the manual.
EN
The safety of this product is only guaranteed when it is used in accordance with its purpose. Maintenance
should only be carried out by qualifi ed persons.
Risk of explosion if the battery is removed with an incorrect type. Contact Adeunis for more information if
needed.
Risk of explosion if the battery is replaced by an incorrect type
Please note: Do not install the equipment close to a heat source or in damp conditions.
Please note: When the equipment is open, do not carry out any operations other than the ones set out in this
document.
Please note: Do not open the product as there is a risk of electrical shock.
Please note: For your own safety, you must ensure that the equipment is switched off before carrying out
any work on it.
Please note: For your own safety, the power supply circuit must be SELV (Safety Extra Low Voltage) and
must be from limited power sources.
Please note: When the aerial is installed outside, it is essential to connect the cable screen to the buil-
ding's earth. We recommend using lightning protection. The protection kit chosen must permit the coaxial cable
to be earthed (eg: coaxial lightning arrester with earthing of the cable at diff erent places on the aerial at the base
of pylons and at the entrance, or just before entering the premises).
The product must be equipped with a switching mechanism so that the power can be cut. This must be close to
the equipment. Any electrical connection of the product must be equipped with a protection device against vol-
tage spikes and short-circuits.
All manuals and user guides at all-guides.com
Page 28 of 44