PowerWalker VFI 1000 TG Mode D'emploi page 21

button less than 0.5 second again. If the new warning or fault alarm is
appeared, the buzzer will beep again.
NO. Status
1 Battery mode
2 Battery mode with
battery low
3
Bypass mode
4 Overload
5 Warning active
(see Warning& Fault
Code Table )
6 Fault active
7 Button function active
6. Operating Mode for All Models
The different string could be displayed on the LCD screen corresponding to
their operating modes, and they are illustrated as the following table. At any
time, only one normal operating string or fault string is presented. But the
warning, even several warnings could appear in a certain normal operating
mode at one time. And the normal operating mode string and the warning
string would be shown circularly. Once one fault is come forth, then all
previous warnings would not be shown again but only the fault string is
presented.
Warning
Site fail
Fan fail
Battery over voltage (over charged)
Battery low
Alarm Table List
Warning& Fault Code Table 6.1
-18-
Alarm
Beep once every 4 sec
Beep once every sec
Beep once every 2 min
Beep twice every sec
Beep once every sec
Beep continuously
Beep once
String
SITE
FANF
HIGH
bLOW