PowerWalker VFI 1000 TG Mode D'emploi page 16

5. Connection and Operation
The system may be installed and wired only by qualified
electricians in accordance with applicable safety regulations!
When installing the electrical wiring, please note the nominal
amperage of your incoming feeder.
5.1 Inspection:
Inspect the packaging carton and its contents for damage. Please
inform the transport agency immediately if you find signs of damage.
Please keep the packaging in a safe place for future use.
Note: To avoid any safety issue, please ensure that the incoming
feeder (mains) is isolated completely while whole installing
process.
5.2 Connection:
(1) UPS Input Connection
If the UPS is connected via the power cord, please use a proper
socket with protection against electric current, and pay attention to
the capacity of the socket. The UPS System has an input breaker on
the standard cabinet.
(2) UPS Output Connection
The output sockets and types of the UPS are shown below:
Model No.
VFI 1000 TG
Output Socket
-SCHUKO(pcs)
3*Schuko
-13-
Output Socket
-IEC(pcs)
4*C13