EUROM Force 2000 Plus Manuel D'instructions page 37

Tips for use
 When the water jet leaves the nozzle it causes the handle to recoil. You must
therefore ensure that you are standing in a stable position and have a firm grip.
Also ensure that the high pressure of the water jet does not cause objects to
move out of place or fall or fly around and cause damage. Also select a safe
location for yourself!
 Keep your work environment clean and tidy.
 The high-pressure jet can cause damage to, for example, tyres if you move the
jet too close. Always maintain a minimum distance of 30 cm from the object to
be cleaned! Always adjust the distance to the object to be cleaned (and
therefore the pressure) appropriately.
 Work from the bottom to the top in the case of vertical surfaces.
 Prevent water from splashing onto undesired places.
 Do not move the cleaner by pulling the electrical cable. Do not lift the machine
up with the cable. Prevent damage to the cable caused by oil, solvents, sharp
edges, etc. Do not cover the machine during use.
 Do not use the machine in an insufficiently ventilated room.
 It is forbidden to clean surfaces containing asbestos with high-pressure.
 If the machine is not used for longer than 5 minutes it must be switched off.
Switching off
 Switch the machine off (Button to 0 - OFF).
 Close the water supply.
 Allow any pressure to escape by squeezing the trigger until no more water
comes out of the nozzle.
 Close the safety lock on the handle.
 Pull the plug out of the socket.
Storage
 Before clearing the machine away, the water must be removed from the pump,
the hose and the accessories. You do this by switching the machine off with the
switch and disconnecting the water supply hose. Now start the machine again
and squeeze the handle. Allow the machine to operate until no more water
comes out of the jet lance. Then switch the machine off immediately. Never
allow it to 'run dry'!
 Remove the plug from the socket, wind the hose up and hang the cable on the
hook.
 Place the handle and the lances in the holders on the machine.
 The machine must be stored frost-free. If this is impossible, have the machine
suck in anti-freeze before you store it. Remember to flush the machine
thoroughly with water before using it again! If the machine nevertheless freezes,
have it checked before use. Frost damage is not covered by the guarantee.
Never start a frozen high-pressure cleaner!
37