EUROM Force 2000 Plus Manuel D'instructions page 36

Position the washer as near as possible to the water supply.

The cleaner must be placed on a strong, flat and horizontal surface (handle up)

(see fig. 3).
Decide which jet lance you wish to use: with narrow/flat jet, with rotating head

or possibly the terrace cleaner. Insert the end of the relevant lance into the jet
pistol and screw it firmly in place (see fig. 4).
Screw the high-pressure hose onto the jet pistol (see fig. 5). Tighten firmly

using the no. 17 spanner.
Connect a normal ½" garden hose (reinforced) of min. 5m. and max. 25m. to

the water supply and turn it on for a short time in order to flush any dirt out of
the hose. Now use a quick connector to connect the hose to the water inlet (see
fig. 7).
Attention!
 The water temperature may not exceed 40°C.
 The pressure of the water supplied may not exceed 0.7 MPA (7 bar).
 Only use clean water with this machine. Impurities or aggressive chemicals
damage the machine!
 Turn the On/Off switch to the OFF 0
 Check that the specifications of the socket that you wish to use correspond with
those on the type plate of the machine. If this is the case, insert the plug into
the socket.
Operation
 Open the water supply completely.
 Unlock the safety lock by pushing the button to the right (see fig. 8).
 Now squeeze the trigger for several seconds in order to de-aerate the hose.
 Switch the machine on by switching the On/Off button to I ON (see fig. 9). The
motor will start briefly, but will stop again as long as the trigger is not squeezed.
 Now squeeze the trigger – the machine will start.
 Take note! Wait at least 3 seconds after releasing the trigger, before squeezing
it in again. If this is not done, the device will 'hiccup'.
 The automatic start/stop system means that the motor only works when
the trigger is squeezed!
 The jet produced by the jet lance can be adjusted from narrow to wide by
turning the head of the lance. Never do this while spraying!
 The rotating head creates a narrow rotating jet.
 The terrace cleaner is intended for the cleaning of hard, even, flat surfaces such
as terraces, small streets, steps, (garden) walls, etc. The cap provides protection
from water splashing back. Attention: the powerful jets can damage softer
materials such as paint and wood, etc. (see for assembly terrace cleaner fig. 13
and 14).
Important: Always point the jet down!
position (see fig. 9).
36