Power Mode; Temperature Mode - Steba IK 70 Mode D'emploi

Power mode

This function is suitable for boiling water and soups.
Place the pot in the middle of the cooking area.
Touch ON/OFF once and after that the power function
shines and the display shows 2000, the slide control is visible. The cooling fan
starts working. With the slide control the power be adjusted in steps of 500W/1100
Watt/1300 Watt/1700 Watt/2000 Watt. During cooking, the Wattage can be changed
at any time.
The unit is equipped with an overheat protection. When the pot gets too hot, the
appliance will stop working, a sound can be heard and the display shows E7. In that
case, press the ON/OFF
ance will work after that without any problems.
Attention! If the failure code E1 is shown in the display, the used pot or pan
is not suitable for induction cookers. The appliance beeps and after ca 30
seconds it switches back into the stand-by mode.

Temperature mode

This function is suitable for roasting meat and vegetables.
Place the pot in the middle of the cooking area.
Touch ON/OFF once and after that the temperature button . A red LED above the
temperature symbol shines and the display shows 140°. With the slide control the
power be adjusted in steps of 60°/80°/100°/140°/180°/220°. During the cooking the
temperature can be adjusted at any time. The build in sensor keeps the temperature
at about the adjusted temperature. If the set temperature is reached, a red LED shine
above the temperature symbol.
Attention! If the failure code E1 is shown in the display, the used pot or pan
is not suitable for induction cookers. The appliance beeps and after ca 30
seconds it switches back into the stand-by mode.
Timer
Set the temperature or power as described above. Touch the timer button
blinking in the display. Now you have a slot f 5 seconds to adjust the time by pressing
the slide control in steps of 5 minutes up to 3:55 hours. An changes will be confirmed
with a beep sound. If nothing is pressed within 5 seconds, the timer will be deacti-
vated again. By setting the time keep the following in mind: touch the slide control
on the right side for minutes and the left side for hours. With any contact the time
increases by 5 minutes or 1 hour and will be confirmed with a beep. If you wish to set
the time faster, keep touching the slide control.
and cool the appliance down for some minutes. The appli-
, the red LED above
. 00:00 is
13