How To Clean - Steba IK 70 Mode D'emploi

∙ If the surface is cracked, switch off and take to the service cen-
ter immediately.
∙ Do not block air intake or exhaust vent.
∙ Do not touch the top plate
shortly after removing the pot or the pan,
as the top plate will still be very hot.
∙ Do not place near objects which are affected by magnet, such
as: radios, televisions, automatic-banking cards and cassette ta-
pes.
∙ The supply cord must by replaced by qualified technicians.

How to Clean

∙ Disconnect plug and wait until it is cooled down. Clean after
each use.
∙ Never immerse the device in Water.
∙ If the pots/pans are used without being cleaned, discoloration
or cooked on stains may be caused.
∙ Do not use petrol, thinner, scrubbing brush or polishing power
to clean the induction cooker.
∙ Wipe using dish washing agent and damp cloth.
∙ Use vacuum cleaner to suck up dirt from the air intake and ex-
haust vent.
∙ Never run water over the unit. (water gets inside may cause
malfunction).
Operation:
The appliance is equipped with a touch control display- All functions will be
activated by touching the surface.
Plug the appliance into the socket. A sound can be heard, all LED and the display are
illuminated for one second. Now the appliance is in stand-by modus. A red LED shines
above ON/OFF . Place a suitable pot in the middle of the cooking area (min. diame-
ter 12cm). By touching the ON/OFF
shines. Attention!!! After 30 seconds the appliance will switch back into the stand-
by modus, when no function
minutes.
12
once 4 stripes and a LED above the ON/OFF
or by touching was chosen. The fan runs for about 2