Power Mode - Steba IK 300 SC Mode D'emploi

Operation:
The appliance is equipped with a touch control display- All functions will be
activated by touching the surface. The usage of both plates is identical.
Plug the appliance into the socket. A sound can be heard and all LED and the display
are on for one second. Now the appliance is in stand-by modus. Place a suitable pot in
the middle of the cooking area (min. diameter 12cm). When the ON/OFF
for one time a LED bellow heating is on and one LED is on above the ON/OFF
tention!!! After 1 minute the appliance will go back into the stand-by modus, when
no function by touching
By touching ON/OFF

Power mode

This function is suitable for boiling water and soups.
Place the pot in the middle of the cooking area.
Touch ON/OFF one time and after that the function
(Zeichen) is on and in the display there is 1200 is shown. The cooling fan starts work-
ing. With the buttons
During cooking the Wattage can be changed at any time.
The unit is equipped with an overheat protection. When the pot gets too hot, the
appliance will stop working, a sound can be heard and in the display E02 can be seen.
In that case, press the ON/OFF
appliance will work after that without any problem.
When the failure code E0 is in the display then the used pot or pan is not
suitable induction cookers. The appliance beeps 9 times and after ca 1 minute
the appliance will switch to the stand-by mode.
If you set the power lower than 400 W, the selected plate turns off.
was chosen.
both plates turn off.
or can the power be adjusted in steps of 200W.
and cool the appliance down for some minutes. The
is touched
, the red LED bellow Heating
. At-
13