entrematic Ditec ION4 Manuel Technique page 97

16.3 Visualisation of alarms and faults
WARNING: the visualisation of alarms and faults is possible with any visualisation selection.
i
The signalling of alarm messages takes priority over all other displays.
Type of
Display
alarm
M3 - Automation blocked
M4 - Motor short circuit
M8 - Stroke too long
M8 - Stroke too short
MB - Absence of motor during an opera-
tion.
MD - Irregular operation of the opening
limit switch
If the limit switch is configured but can't be
found, each stop (from the OB deceleration
start point) is seen as an obstacle and indi-
cated with MD.
ME - Irregular operation of the closure
limit switch
If the limit switch is configured but can't be
found, each stop (from the CB deceleration
start point) is seen as an obstacle and in-
dicated with ME.
MI - Detection of fifth consecutive obstacle. Check for the presence of permanent ob-
OD - Obstacle during opening
OE - Obstacle during closure
OF - Automation blocked on opening
OG - Automation blocked on closure
S6 - Incorrect setting of safety device test
Description
43
Operation
Check the mechanical parts.
Check connection of motor.
Check the rack / chain belt
Manually check that the gate moves free-
ly.
Check connection of motor.
Check connection of the opening limit
switch.
Check connection of the closure limit
switch.
stacles along the stroke of the automation.
Check for the presence of obstacles along
the automation stroke.
Check for the presence of obstacles along
the automation stroke.
Check the mechanical parts and make sure
there are no obstacles along the automa-
tion stroke.
Check the mechanical parts and make sure
there are no obstacles along the automa-
tion stroke.
Check the configuration of parameters
, , .
If → , and
.
cannot be or
EN