Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Set the controls to automatic mode operation:
- Push the ON / OFF button [30] to turn the refrigerator
on (See Art01809 and Art01811).
- Push and hold the MODE button [31] until a red
triangle shows under the mode symbol and then
release.
- If 120 volts AC is available to the refrigerator:
- A second red triangle shows under the electric
plug part of the mode indicator [186].
- This means that the refrigerator is operating
on AC electric.
- If 120 volts AC is not available to the refrigerator:
- A second red triangle shows under the gas
flame part of the mode indicator [186].
- This means that the refrigerator is operating
on propane gas.
- If neither 120 volts AC nor propane gas is
available to the refrigerator:
- The fault codes "no" "AC" and then "no" "FL" show in the center display [33] of the LCD and an audible alarm sounds.
If an energy source is available to the refrigerator, but is not operating correctly:
- A fault code shows in the center display [33].
- The refrigerator controls try to change to a less efficient energy source.
- If a less efficient energy source is not available:
- An audible alarm starts.
- A fault code shows in the center display.
- Refer to the "Fault Codes" section of this manual.
Set the controls to manual mode operation:
- Push the ON / OFF button to turn the refrigerator on.
- Push and hold the MODE button until NO red triangle shows under the mode symbol and a red triangle shows under the electric
plug part of the mode indicator and then release.
- This means that the refigerator is operating on AC electric.
- Push and hold the MODE button until NO red triangle shows under the mode symbol and a red triangle shows under the gas flame
part of the mode indicator and then release.
- This means that the refigerator is operating on propane gas..
30
31
Art01809
185
Art01811
107
186
33
187
Installation Manual 19
32
184
Publicité
Chapitres
Table des Matières
