Removing The Air From The Propane Gas Supply Lines; Set The Controls To Automatic Mode Operation - Norcold N41X Mode D'emploi

Removing air from the propane gas supply lines:
For safety reasons, the burner is made to ignite on propane gas within a specified amount of time. When starting the refrigerator for
the first time, after storage, or after replacing propane gas tank, the propane gas supply lines can have air in them. Due to the air in the
gas supply lines, the burner may not ignite on propane gas within the specified amount of time.
To remove the air from the propane gas supply lines:
- Make sure that all of the gas valves are open.
- Push the ON / OFF button to turn the refrigerator on.
- Push and hold the MODE button until the light bar beside LP GAS [36] shows.
- This means that the refrigerator is operating on propane gas.
- If the air in the propane gas supply lines prevents the burner from ignition on propane gas, the fault code "F" will appear in the
center display.
- Push and hold the ON / OFF button for one second and then release to turn the refrigerator off.
- Push the On / Off button to turn the refrigeratro on.
- The refrigerator will start a 30 second trial for ignition.
- During the 30 second trial for ignition, the refrigerator controls open the gas safety valve and the igniter sparks.
- After 30 seconds, the refrigerator controls closes the gas safety valve and the igniter stops sparking.
- When the light bar beside the LP GAS shows and no fault code remains, this means that the refrigerator is operating on propane
gas.
- At this time, all of the air is removed from the propane gas supply lines and you may select AUTO mode of operation if you
wish.
- Depending on how much air may be in the propane gas supply lines, you may need to repeat the 30 second trial for ignition two or
three times.
- If the burner does not ignite on propane gas after two or three attempts, stop and consult your local dealer or an authorized
Norcold Service Center.

Set the controls to automatic mode operation:

- Push the ON / OFF button to turn the refrigerator on.
- Push and hold the MODE button until the light bar shows beside AUTO [34] and then release.
- If 120 volts AC is available to the refrigerator:
- The light bar beside AC [35] also shows in the center display.
- After ten seconds, the light bar beside AC goes off and only the light bar beside AUTO remains.
- This means that the refrigerator is operating on AC electric.
- If 120 volts AC is not available to the refrigerator:
- The light bar beside AC also shows in the center display.
- After a few seconds, the light bar beside AC goes off and the light bar beside LP GAS shows.
Owner's Manual 6