Connect The Electrical Components - Norcold 2117X Serie Manuel D'installation

Masquer les pouces Voir aussi pour 2117X Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

- Pull using a wire-form tool hooked into mounting holes [121] of the
refrigerator frame (See Art01808).
Make sure the foam combustion seal is not
!
WARNING
broken, is completely around the refrigerator
mounting flanges, and is between the mounting
flanges and the wall of the enclosure If the seal
is not complete, exhaust fumes can be present
in the living area of the vehicle. The breathing of
exhaust fumes can cause dizziness, nausea, or in
extreme cases, death.
3. Put the refrigerator in position:
Make sure the combustion seal is not broken,
!
WARNING
is completely around the refrigerator mounting
flanges, and is between the mounting flanges
and the wall of the enclosure If the seal is not
complete, exhaust fumes can be present in
the living area of the vehicle. The breathing of
exhaust fumes can cause dizziness, nausea, or in
extreme cases, death.
Be careful when you put the refrigerator into position. The
NOTICE
refrigerator has vacuum insulating panels on the top and
sides. If punctured, these panels lose insulation value which
decreases the cooling performance of the refrigerator. It is not
necessary to remove the protective packaging from the doors
of metal door models to install or operate the refrigerator.
- Make sure that the flue cap is not pushed down against the top of the flue
tube.
- Push the refrigerator completely into the enclosure.
4. Install the mounting screws and trim (See Art01814):
- Put the four screws [41] through both the upper and the lower mounting
flanges on the front of the refrigerator and into the enclosure wall.
- Push the trim pieces [40] onto the front of the refrigerator.
- Put screws through the mounting flange on the rear of the refrigerator and
into the floor.
5. On metal door models only, you may wish to remove the protective
packaging from the doors.
Be careful to not scratch or dent the metal doors. Do not use
NOTICE
any abrasive cleaners, chemicals, or scouring pads because
they can damage the fininish of the doors.

Connect the Electrical Components

This refrigerator operates on these electrical sources. Operation out of these limits may damage the refrigerator's electrical circuit parts
and will void the warranty.
AC Operation
120 volts AC voltage
12 volts DC control voltage
Installation Manual 14
Art01850
(132 volts max. - 108 volts min.)
(15.4 volts max. - 10.5 volts min.)
209
41
41
40
41
40
Art01814

Publicité

Chapitres

Table des Matières
loading

Table des Matières