Automatic Mode Operation; Manual Ac Mode Operation; Shut Down-All Models; Operating The Refrigerator Controls (N7Lx And N8Lx Models) - Norcold Polar 7 Série Manuel D'installation

Shut down - All models:
- To shut down the refrigerator, touch and hold the ON/OFF button for two seconds and then release.
Operating the Refrigerator Controls (N7LX & N8LX Models)

Automatic Mode Operation:

Control boards are extremely sensitive. Evidence of tampering or removal from protective case
NOTICE
will VOID any warranty.
- Touch and release the ON/OFF button [30] to turn the refrigerator on. (See Art 02629).
- Touch the TEMP SET button [32] as needed to set the
temperature setting.
- Number one (1) shown in the display [187] is the warmest
setting.
- Number nine (9) shown in the display [187] is the coldest
setting.
- If the AUTO icon [277] and AC PLUG icon [278] are lit up, it
means that:
- 120 volt AC power is available to the refrigerator.
- The refrigerator is operating on AC electric power.
- After ten seconds, the backlight of the display goes off.
- If the AUTO icon and the FLAME icon [289] are lit up, it means that:
- 120 volt AC power is not available to the refrigerator.
- The refrigerator is operating on propane gas.
- After ten seconds, the backlight of the display goes off.
If neither 120 volts AC nor propane gas are available to the refrigerator :
- The fault codes "no AC" and then "no FL" show in the display and an audible alarm sounds.
- Refer to the "Fault Codes" section of this manual for any faults displayed.
If an energy source is available to the refrigerator but is not operating correctly:
- While operating in the Automatic mode, the refrigerators electronic controls will automatically select the energy source using the
following priorit scheme:
1st choice: AC Electric
2nd choice: LP GAS
3rd choice: DC Electric (3-way refrigerators only)
- When in the Auto mode, if a higher priority choice becomes available (i.e., AC voltage reapplied), the control shall stop
using the current mode and switch to the higher priority mode.

Manual AC Mode Operation:

- Touch and release the ON/OFF button [30] to turn the refrigerator on.
- Touch the MODE button [31] until the AUTO icon goes off and only the AC PLUG icon [278] remains lit.
- Touch the TEMP SET button [32] as needed, to set the temperature setting.
- The AC PLUG icon [278] remains lit until you select a different operating mode or shut down the refrigerator.
278
MODE
NORCOLD
30 31
361 289
set
AUTO
CODE
277 187 32
Art 02629
Installation Manual 19