Install An Air Deflector (Optional); Install Decorative Door Panels (Non-Metal Door Models) - Norcold 2117X Serie Manuel D'installation

Masquer les pouces Voir aussi pour 2117X Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

- Make sure that the horizontal top of the solid box baffle is even with the bottom edge of the upper exhaust vent [24].
- Make sure that the vertical top edge of the solid box baffle is 1/2 inch or less [170] below and 1/4 inch or less behind [15] the
lower rear corner of the condenser [11].

Install an Air Deflector (optional)

If the floor plan has the refrigerator on the rear wall of the vehicle, obey all of the vent installation as written in the "Install the Lower and
Upper Vents" section of this manual. Install the roof exhaust vent so that:
- The sloped end of the roof exhaust vent is toward either side of the vehicle.
- The roof exhaust vent is perpendicular to the air flow over the
vehicle.
Install an air deflector on the roof of the vehicle between the roof
exhaust vent and the front of the vehicle (See Art01767).
- Make sure that the air deflector [175] is between the roof
exhaust vent [24] and the front of the vehicle [179].
- Make sure that the air deflector is at least 3 1/2 inches high
[176].
- Make sure that the overall width [177] of the air deflector is 32
7/8
- Make sure that the distance between the air deflector and the
roof exhaust vent is between 2 and 3 inches [178].

Install Decorative Door Panels (non-metal door models)

The doors are made to accept decorative panels. The decorative panels must be 3/16 inch or less in thickness. Install
NOTICE
the decorative door panels in the refrigerator doors before installing the refrigerator in the vehicle.
1. Make two upper door panels that are 17 1/4 inches wide x 23 1/8 inches
high:
- Raised panels must be centered on each door and no larger than 16
1/2 inches wide x 22 3/8 inches high.
2. Make two lower door panels that are 17 1/4 inches wide x 42 5/16
inches high:
- Raised panels must be centered on each door and no larger than 16
1/2 inches wide x 41 9/16 inches high.
3. Install the decorative door panels:
- Pull the panel retainer [37] off of each door [39] (See Art01804).
- Push a decorative door panel [38] into the slots of each door.
Installation Manual 12
175
176
177
179
39
24
178
Art01767
38
37
Art01804

Publicité

Chapitres

Table des Matières
loading

Table des Matières