Install The Refrigerator - Norcold 2117X Serie Manuel D'installation

- Make sure that each panel retainer is correctly positioned and push the
curved snaps [125] of the panel retainer [37] inside of the curved snaps
[126] of the door (See Art01805).

Install the Refrigerator

When manually (by hand) or mechanically (by hoist, lift truck, etc.) handling
a refrigerator that is not installed in an enclosure, the best method is while
the refigerator is in its original packaging.
If the refrigerator is not in its original packaging, use the handling straps
[183] of the refrigerator cabinet as the primary load carrying points (See
Art01808). There are two (2) handling straps on both the right and left side
of the refrigerator cabinet.
These handling straps may be used to lift, move, and tilt the refrigerator.
Norcold recommends that all lifting, moving, and tilting of the refrigerator is
always done by at least 2 persons.
Use only the handling straps to lift, move, or tilt the
!
CAUTION refrigerator. Using any part of the refrigerator other
than the handing straps, to lift, move, or tilt it can
result in damage to the refrigerator.
1. Remove the packaging support block (See Art01850):
- Open both lower doors of the refrigerator.
- Remove and discard the two screws [41] from the front of the lower
mounting flange of the refrigerator.
- Tilt the refrigerator back just enough to remove the wooden packaging
support block [209] from behind the lower mounting flange.
- Close the doors.
2. Put the refrigerator completely into the enclosure:
- Push below the center of the refrigerator.
183
Art01808
37
126
125
Art01805
121
Installation Manual 13