B.A. International Ultimate BASE290 Manuel D'utilisation page 6

6
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
! ! !
! ! !
!
! ! ! !
! ! ! !
# ! ! !
! ! !
!
(
!
! !
On power levels three and four, a three second delay follows the
cure cycle with an alarm to indicate that re-activation is available.
End of cure cycle is indicated by an audible and/or tactile (vibrate) alarm,
both of which are optional.
To enable/disable the audible alarm; set the cure power to minimum
setting and then press and hold the key to the left for three seconds, the
unit will confirm a change with a bleep.
To enable/disable the tactile alarm; set the cure power to maximum setting
and then press and hold the key to the right for three seconds, the unit will
confirm a change with a vibrate.
! ! ! !
! ! !
If a cure cycle is interrupted by all lights flashing and the unit vibrating
7 times, this indicates that the battery level has dropped too low for
the handpiece to operate.
! ! !
! !
MODES OF OPERATION
! !
HIGH POWER
Power Setting
Level 4
Level 3
( Level 2 (
Level 1
To assure correct curing follow the composite manufacturer's
individual product guidelines for cure power and duration.
! ! ! !
Duration of cure settings are
selected by moving the Navikey
forwards and backwards are
displayed via the row of green
indicators.
The cure cycle is activated by
pressing the Navikey.
A second press of the Navikey will
terminate the cure cycle at any
time.
!
! ! ! ! !
! !
! !
! ! ! ! ! !
Duration (T)
Power (P)
(mW/cm 2 )
(Seconds)
3000 1 3
2000 1 3
1000 1 5
600 1 5
! ! ! !
! ! !
! ! ! !
5
5
10 20
10 20
! ! ! !