Festo KSK Série Notice D'utilisation page 25

KSK−...
During the test run check that the axis
S
system runs smoothly.
Alignment faults, offset and tension in
the system lead to point by point or
continuous bad running.
Increase the speed step by step until
S
the maximum positioning speed during
operation is reached.
Conclude the test run.
S
7 Operation
Please note
Bent or damaged shafts and couplings will break after a certain amount of time.
S Make sure that the elements of the KSK−... are not damaged and that unex
pected shaft fracture cannot cause any damage, e.g. by providing protective
screening or covers.
8 Care and maintenance
Tighten coupling screws which are still loose.
S
Make sure that the couplings are not damaged.
S
If the coupling is defective, x−axis 1 will drag x−axis 2 on the slide. Such a drag
operation will considerably reduce the service life of the axes.
Otherwise the KSK does not require any maintenance.
Festo KSK−... 0804b
Fig. 24
25