Festo KSK Série Notice D'utilisation page 22

KSK−...
Complete the alignment as follows:
S
1. Push both x−axis slides by hand into
the same end position.
2. Place the y−axis on the x−axis with the
aid of the fastening elements.
3. Loosen the fastening screws for height
adjustment of x−axis 2 and adjust the
height in respect of x−axis 1.
4. Shift the y−axis backwards and forwards over the complete positioning path
of the x−axes. The loose axis will align itself parallel with the fixed axis.
5. Tighten the fastening screws of the x−axis 2.
Preparing for fitting (only with KSK in conjunction with toothed−belt axes EGC)
1. Remove the sealing disc 8 from the
desired connection side (e.g. with a
screwdriver).
2. Push the slide into the end position, in
which the hollow shaft is prevented from
turning when the drive shaft is tightened.
3. Push the drive shaft provided as far as
possible into the hollow shaft of the EGC.
The appropriate tightening torque is
shown in the table below.
Note that excessive tightening torques
S
can damage the EGC.
KSK−...
Tightening torque
Fig. 17
With KSK−185:
Push the plugs 4 provided for tube clamping as far as possible in both ends of
S
the connecting shaft.
22
50 70
[Nm] 1 1.5
X1
Fig. 14
8
Fig. 15
Fig. 16
80 120
7 14
Festo KSK−... 0804b
Y
X2
185
60