Festo KSK Série Notice D'utilisation page 21

KSK−...
Please note
The asymmetrical product geometry of the
EGC can lead to mounting faults.
S Note the different distances between the
centre of the guide and the front and
rear cover surfaces LH and LV.
Connection is possible at all four hollow
shaft ends and must be carried out in
accordance with the planning.
With EGC−...−TB−KF−...−Z with shortened hollow shafts:
Please note
S Note that with type EGC−...−TB−KF−...−Z,
the drive shaft can only be fitted on the
front.
Compare the supplier's specifications for
S
your KSK with the project planning data.
They contain the intended rated length L
for you parallel structure;
(e.g. KSK−40−1000 } L = 1000 mm).
Place the toothed belt axes in position at
S
the intended horizontal distance L from
each other in accordance with Fig. 13.
For DGE: L Z distance from centre of
For EGC:
Definition
x−axis 1 = fixed axis
x−axis 2 = loose axis
y−axis
Fasten the fixed axis to the basic structure. It must be possible to shift x−axis 2
S
in the x−y level.
x−axis 2 is fastened in alignment with x−axis 1 vertically as well as horizontally
(parallelism of the guides).
Festo KSK−... 0804b
axis to centre of axis
L Z Inside width between the
drive covers
= transverse axis over both x−axes
Fig. 11
Fig. 12
DGE
EGC
Fig. 13
21