Corghi LaserLine EM 9550 Manuel D'utilisation page 46

Assembly of the ultrasonic
sensor and its "optional
accessory supplied on request"
support for automatic width
measurement
- insert the ultrasonic sensor cable inside the
slots in the metal pipe (see fig.9) fixing the
cable using the supplied hose clamp (A, fig.9)
- fix the ultrasonic sensor support to the guard
pipe using the supplied screws (Fig.9a);
- connect the sensor cable to the connector on
the side of the casing (A, fig.9b)
46
IMPORTANT: once the ultrasonic sensor is as-
sembled, calibrate the sensor as described in
the paragraph "Calibration of the ultrasonic
width sensor".
After assembling the machine, position it in the
selected place and make sure that the spaces
surrounding it are at least equal to the ones
indicated in fig.10.
9
9a
EM 9550 - Operator's manual
9b
10