Lighting Led And Laser Activation/Deactivation; Wheel Roundness Visual Inspection; Calibration Programmes - Corghi LaserLine EM 9550 Manuel D'utilisation

LIGHTING LED AND LASER
ACTIVATION/DEACTIVATION
To change or deactivate the control of the LED
light, proceed as follows:
- Press the
gramme menu
- use the
cursor
- select the programme
- press the button to confirm programme
selection;
- Pressing the
the user to set alternatively the three light control
modes, as follows;
LEd 1. In this configuration, the light turns on
when:
- at the end of a spin cycle if residual unbalances
are present for 30 seconds;
- in CP (centred position) for an additional 30
seconds.
LEd 2. In this configuration, the light turns on in
the conditions indicated for the LEd1 programme
and, in addition, also in the following conditions:
- when the internal sensor is extracted. When
the sensor returns to the rest position, the light
turns off;
- during the entire measurement cycle with all
balancing programmes;
- during the Hidden Weight programme when
selecting the two planes behind the spokes.
LED OFF: deactivated
- Press the
and exit the programme menu.
To deactivate the switching on of the LASER line,
proceed as follows:
- press the
gramme menu
- use the
cursor
68
button to access the pro-
buttons to move the
button consecutively allows
button to confirm selection
button to access the pro-
buttons to move the
- select the programme
- press the button to confirm programme selection;
- press the
gramme selection;
- Pressing the
makes it possible to alternatively set the two
LASER line control modes (LAS on or LAS oFF)
- Press the button to confirm selection
and exit the programme menu.
WHEEL ROUNDNESS
VISUAL INSPECTION
This function allows the wheel to be run at low
speed and with the guard open, Any geometrical
irregularities of the rim and wheel can therefore be
visually checked. Follow the description detailed
below to start the procedure:
keep the button pressed with the guard
open for as long as necessary for wheel inspection.
When the button is released, the wheel-holder shaft
locking device activates automatically.
CALIBRATION
PROGRAMMES
Sensitivity Calibration
Calibrate when detecting that the setting condition
is out-of-tolerance or when the machine so requires
as the E 1 message is displayed.
Calibrate as follows:
1. keep the
least three seconds to access the complete
programme menu;
2. use the
cursor;
3. select the
EM 9550 - Operator's manual
or button to confirm pro-
button consecutively
button pressed for at
buttons to move the
programme;