Fitting And Adjusting The Curved Guard - Festool CMS-GE Guide D'utilisation

Tighten the screw [26-2].
Adjusting the press-down fi xture
Adjust the bearing shoe on the press-down fi xture
so that the workpiece is guided straight and does
not stray to either side. The bearing shoe prevents
inadvertent contact with the cutter tool.
27-3
27-2
27-1
Fitting the curved guard
Install the curved stop (curved guard) when per-
forming routing work on cambered (curved) work-
pieces.
Secure the curved guard [28-2] by inserting the
three screws [28-1] in the three holes [28-5] and
attach the guide rail [28-3] by inserting the long
screw in the hole [28-4].
28-2
28-1
16
27-4
27-5

Fitting and Adjusting the curved guard

28-3
28-1
28-4
28-5
Unscrew the rotary knob [27-5].
Lower the vertical bearing shoe [27-3] down to
the workpiece.
Tighten the rotary knob [27-5].
Loosen the screw [27-4].
Slide the horizontal bearing shoe [27-1] down to
the workpiece. If the workpiece is wider than the
adjustment range of the horizontal bearing shoe,
turn the horizontal bearing shoe vertically.
To turn the horizontal bearing shoe, re-
lease the lever [27-2] and swivel the com-
plete press-down fi xture upwards.
WARNING
Risk of injury
Before working with the machine, always
swivel the press-down fi xture down again until
the lever [27-2] engages.
• Tighten the screw [27-4].
Adjusting the curved guard
Adjust the curved guard until the transparent pro-
tective cover [29-1] rests on the workpiece.
Loosen the two screws [29-2].
Adjust the height of the protective cover [29-1]
so that it rests on the workpiece.
Tighten the two screws [29-2].
Adjust the guide rail:
Loosen the screw [29-5].
29-1
29-2
29-3
29-4
29-5