Control Module Cover Removal; Control Module Removal - Parker AC30 Serie Démarrage Rapide

Control Module Cover Removal

To gain access to the control wiring, and SD Card, first remove the control module cover as follows:
First remove the GKP by pulling from the top down,
and remove.
For Through Panel Mounting unscrew and
remove mounting brackets.

Control Module Removal

WARNING Isolate supply before plugging or unplugging control unit to the power stack.
2.
Lift lower edge of assembly.
Note that there are two
screws used to retain the
AC30D control module.
The communications
option, if fitted, should be
temporarily removed to
access one of the two
screws.
This manual was downloaded on www.sdsdrives.com
+44 (0)117 938 1800 - info@sdsdrives.com
1.
Unscrew
captive screw.
Undo the screw and slide the control module
cover down slightly, then remove.
4.
Lift assembly away from Power Stack
1-5
English
3.
Slide assembly
upwards, as far
as possible, to
unlatch from unit.