Lenz Digital Plus 10104 Manuel page 33

59 0-255 Lighting effects at function outputs C and D.
The tens digit of the value
stands for function output D:
0 No effect
1 Flashing simultaneously
with function output C
2 Flashing alternately to
function output C
3 Flickering Type 2 (less
sooth)
4 Flickering Type 3
(excitedly)
Function mapping for effects:
60
If value 10 is entered in the CV (no bit set), the corresponding
–
output is permanently dimmed. If an allocation is entered (value
63
greater than 0, at least one bit set), the dimming can be
activated/deactivated with the selected function.
Each bit of the CV stands for a function of the Digital System:
Bit 1(0) for function 1, Bit 2(1) for function 2 and so on up to
Bit 8(7) for function 8. If you want to allocate a function to the
dimming, the respective bit must be set.
60 Effect mapping for output A
61 Effect mapping for output B
62 Effect mapping for output C
The units digit of the value
stands for function output C:
0 No effect
1 Flashing
2 Flickering Type 1 (smooth)
33
0
E
0
0
0