Publicité
Les langues disponibles
Les langues disponibles
Basic circuit of the control car after conversion:
red
black
Programming the locomotive address and the function settings of the LF101XF
The locomotive address and all other settings of the locomotive decoder can be changed as often
as desired by PROGRAMMING. The settings of the function decoder are 'stored' permanently in
several 'storage' locations even when the operational voltage is switched off. In American parlance
these locations are called 'Configuration Variables' or simply 'CV'. The writing/reading of values is
done electronically, therefore it is not necessary to reopen the locomotive after the decoder has
been installed. Some features are not activated/deactivated by entering a decimal value, but simply
by setting or deleting bits in a CV. The table below lists the meanings of bits wherever features are
changed by setting or deleting individual bits.
To program the locomotive decoder you need a command station LZ100/LZV100 with a manual
control LH100 or the Interface; a SET02 or a Compact. For detailed information on programming,
please refer to the operating manuals of the respective devices.
By default, the decoder is set as follows(Of course, these default settings can be changed):
Decoder
Direction
yellow
Internal
lighting
of the coach
white
27
E
Publicité
