Lenz Digital Plus 10104 Manuel page 19

Important safety instructions
The function decoder LF101XF is to be used only with Lenz DIGITAL plus or other standard
digital controls with an NMRA-conformance seal. If in doubt, ask the system supplier.
The maximum current-carrying capacity of the decoder outputs must not be exceeded as this will
destroy the decoder! The parts of the decoder must not be allowed to touch the metal
components of the chassis or the body of the locomotive as this will cause a short-circuit within
the decoder resulting in its destruction.
Never wrap the decoder in insulating tape as this prevents the necessary air circulation around
the decoder. Instead, use insulating tape or something similar around the metal components of
the vehicle to avoid unintentional short-circuits without depriving the decoder of air. If a heat-
shrink or insulating sleeve is installed ex-works to protect contact-sensitive components, this
sleeve may not be removed. Use double-sided adhesive tape to affix the decoder.
Features of the function decoder LF101XF
The LF101XF is a DCC function decoder used to switch functions in locomotives or coaches. (In
analogue mode, the decoder functions are inactive). A total of six outputs are available.
A typical application is the switching of coach lights or the direction-dependent front light of control
cars. The LF101XF has a special drive for diode-equipped control cars. The LF101XF also supports
numerous lighting effects:
19
E