Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
II - Mechanical installation
1) Unhook the wall support (A) from the clock using the key (B),
then remove the plug-in connectors.
2) Fix the support (A) to the desired spot using the 4 wall plugs
and the 4 screws provided.
■
Hooking onto a vertical bracket or side bracket : support (A)
fits onto bracket reference no. 935001, and also to the chain
suspension reference no. 935002.
■
A tabletop support is also available, reference no. 935003.
III - Electrical power supply
1) Remove the black protective cover on the terminal block (C).
2) Connect the mains power supply - 230 VAC 50/60 Hz depending on the model - to the
terminal block (maximum wire cross section 1.5 mm2 with 5 mm bare).
3) Replace the protective cover. Secure the wires with tie wraps (S).
N.B.: The Style clocks have been designed for a mains power supply of 230 VAC
± 10% 50/60 Hz.
This clock is protected by a 1,25 A - 250 V fuse (F1).
The mains supply unit for this clock must include a 10 A interlocked circuit breaker.
This circuit breaker has to be switched off in case of maintenance operation.
E.g. 230 V clocks will work equally well in countries where the nominal mains voltage is
220 or 240 Volts.
4) If the clock is a part of a time distribution network, or if it has a built in radio antenna (Radio
FI or DCF) or to a timer control unit, please follow the instructions in Chapters 4 to 8.
5) Carry out configuration, set the time and adjust the clock's light intensity as indicated in
Chapters 9 to 11.
6) If the display gets "stuck" at a particular time, check that the operating mode that you have
selected is "Ind" (cf. Chapter 9).
16
E
D
The buttons are not visible on the
Waterproof Style 12 (see chapter 9)
C
S
Publicité
Table des Matières
