Virtus VN8 Mode D'emploi page 13

6. INSTALLATION
For an optimum functioning of the unit it is advisable to place the refrigerator in a zone with a good exchange of air
and far away from any sources of heat.
6.1 SETUP
•. Carefully.remove.the.packaging.from.the.refrigerator;
•. Remove.the.white.PVC.protection.film.from.the.stainless.steel.and.all.the.protection.used.by.the.company.to.reduce.the.
risk.of.damage.during.transport;
•. Place.the.refrigerator.on.a.flat.level.surface.(use.the.adjustable.feet)(Fig..1)
Before use, clean the refrigerator with a clean, soft cloth or using a spray product. It is best use little water as it contains
minerals.which.leave.traces.which.are.difficult.to.remove.quickly;
•. W ash.the.tray.and.all.the.internal.parts.using.anti-bacterial.detergents.to.be.found.commercially;
•. Remove.the.detergent.with.a.soft.sponge.soaked.in.water.and.dry.with.a.clean.soft.cloth;
Do not use abrasive detergents or powders which could make the finish opaque. During these phases do not, as already
stated,.use.great.quantities.of.water.which.could.damage.electric.parts;.a.damp.sponge.is.sufficient.
•. Place.the.self.support.inside.the.refrigerator,.in.the.most.suitable.position.for.use,.inserting.each.support.in.to.the.holes.
on the base of the refrigerator and inserting the side tab in the appropriate place on the sides or on the table supports.
(Fig. 2)
•. Slide.the.shelf.into.the.supports.as.shown.in..(Fig..2)
•. Slide.into.the.appropriate.runners,.on.the.lower.part.of.the.refrigerator,.the.condensation.waste.tray.and.for.appliances.
which have automatic trays, connect the connector. (Fig. 3)
6.2 PREARRANGEMENTS
•. Check.that.the.cables.and.the.sockets.are.suitable.for.the.power.absorbed.by.the.equipment.
THE USE OF ADAPTORS, MULTIPLE SOCKETS AND/OR EXTENSION LEADS IS FORBIDDEN.
•. Ensure.that.the.upright.and/or.table.refrigerator.is.not.installed.near.to.sources.of.heat.like:.ovens,.radiators,.direct.sun-
light etc.
•. Leave.a.space.of.at.least.75.mm.(3.inches).between.the.back.of.the.upright.and/or.table.refrigerator.and.any.wall,.to.avoid.
the formation of condensation.
•. T he.motor.must.be.free.of.any.obstacle.which.could.hinder.or.limit.the.circulation.trough.the.condensing.unit.situated.on.
the top side part of the refrigerator.
•. T he.distance.between.the.refrigerator.and.the.ceiling.must.be.less.50.cm..(19.¾.inches).
•. Check.that.the.environment.has.a.sufficient.change.of.air,.in.order.to.guarantee.the.cooling.of.the.condenser.and.the.
compressor unit.
•. For.a.perfect.functioning.of.the.equipment,.the.maximum.temperature.of.the.environment.should.not.exceed.+43°C.(109.
°F),..except.for.static.models.which.should.not.exceed.+32°C.(+95°F).
Lack of respect for these conditions will provoke a serious decline in the functioning of the equipment, early ageing of the
compressor and a much higher consumption of energy than normal.
6.3 CONNECTION
To.avoid.any.kind.of.problem.when.upright.and/or.tables.are.switched.on.is.good.to.attend.to.the.instruction.as.follow
6.3.1 ELECTRICAL
The.electrical.connection.of.the.upright.and/or.table.refrigerator.is.the.Customer's.responsibility..The.connection.to.the.
power supply must respect the power supply laws in the country in which the equipment is installed(see plaque A)
•. Check.that.the.tension.of.the.power.supply.is.exactly.that.shown.on.the.plaque..(see.plaque.A)
•. Check.that.the.socket.conforms.to.power.regulations.
•. Pay.particular.attention.that.there.are.no.uncovered.wires.
•. Check.the.earth.
THE EARTH CONNECTION IS A LEGAL SAFETY REQUIREMENT.
If more than one pieces of equipment is placed in line, each one must have an independent power supply.
Figure 1 Figure 2
11
Figure 3