Adjusting The Settings On The Profibus Master - Aventics PROFIBUS DP Mode D'emploi

AVENTICS | PROFIBUS DP | R412009414-BDL-001-AE
7.2.2

Adjusting the settings on the Profibus master

After you have configured the controller, you can adjust the
settings of the Profibus master assembly.
Set the baud rate and the address of the assembly.
1. Double-click on the symbol Profibus/M.
The settings window will open up.
2. In the tab Busparameter (Bus parameters), select the
desired baud rate from the table of possible baud rates.
3. Type in the address directly, preferably address 1 for the
master, or select the value by clicking the arrow keys.
Commissioning/Operation
79