Testing And Diagnosis On The Bus Coupler; Reading The Diagnostic Display On The Bus Coupler - Aventics PROFIBUS DP Mode D'emploi

Coupleur de bus pour bdc, design b
Masquer les pouces Voir aussi pour PROFIBUS DP:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 93
AVENTICS | PROFIBUS DP | R412009414-BDL-001-AE
7.3

Testing and diagnosis on the bus coupler

7.3.1
Reading the diagnostic display on the bus
coupler
The LEDs on the front panel of the bus coupler show the
messages from Tab. 13.
O
Before commissioning and during operation, regularly
check bus coupler functions by reading the diagnostic
displays.
Tab. 13:

Reading the diagnostic display on the bus coupler

LED
Signal
Description
UL/
Green
Logic supply available
DIA
Red
Valve or sensor supply overload (group diagnosis)
Off
No logic supply available
U
Green
Valve supply U
Q1
Red
Low voltage (12 V < U
Off
Valve supply U
U
Green
Valve supply U
Q2
Red
Low voltage (12 V < U
Off
Valve supply U
BF
Green
Slave is in "data exchange mode",
i. e. the slave has been parameterized and is
accessed by the master in cycles (RUN).
Red
Bus error, the bus connection is trying to find the
baud rate. Possible causes:
W
Bus cable is not attached
W
Master has been switched off
1)
This display appears only as long as the overloaded output is controlled.
Commissioning/Operation
ok
Q1
< 21.6 V/20.4 V)
Q1
< 12 V
Q1
ok
Q2
< 21.6 V/20.4 V)
Q2
< 12 V
Q2
83
1)

Publicité

Table des Matières
loading

Table des Matières