Publicité
Les langues disponibles
Les langues disponibles
Installation
Pool cut-out for foil/poyester pools
Fig. 11
Mounting the main housing in a foil, polyester, steel or
aluminium pool (A)
NOTICE
Only tighten the screws hand-tight. Do not use any force!
1.
Position the top outlet connection (B) above the inlet
connection (C).
2.
Installation depth: The middle of the nozzle should be
attached 25 cm below the water level.
3.
Drill holes using the enclosed drilling template.
4.
Cut out the housing opening in the pool wall.
5.
Insert the nub seal (26) in the housing (1).
6.
Align the housing (1), place it onto the outer pool wall and
fasten it to the pool wall (without film) using the two tapping
screws (103).
7.
Lay the clamp ring seal (27) from the inside of the pool.
24 EN
06|2020
Publicité
