Speck pumpen BADU JET Smart Traduction Du Instruction D'utilisation Originale page 66

Safety
2.7.6 Danger of injury at the inlet nozzles
Inlet nozzles and massage accessories operate at high pressure
and with high flow speeds. This can result in injuries to eyes or
other sensitive body parts.
 Avoid direct contact of these body parts with the water jet
from the inlet nozzles or the massage accessories.
2.8 Faults
 In case of a fault, immediately switch the pump off and
remove it from operation.
 Have all faults repaired immediately.
Seized pump
If a pump seizes, and is switched on several times repeatedly, the
motor can be damaged. Observe the following points:
 Do not switch the pump/unit on repeatedly.
Turn the motor shaft by hand. See point 6.1.1 on page 37.

 Clean pump.
2.9 Preventing material damage
2.9.1 Leakage and pipe breakage
Non-observance of the curing time of the ABS bonding can result
in leaks and flooding
 Observe the curing time of at least 12 hours for the ABS
bonding
 Provide sufficient ground drainage
Vibrations and thermal expansion can cause pipes to break.
 Install the pump/unit in a manner which reduces structure-
borne and airborne noise transmission. When doing so,
observe relevant regulations.
If the pipe forces are exceeded, leaks can occur at the screwed
connection or the pump itself.
 Do not use the pump as a fixed point for the pipe line.
 Connect pipes free of load and mount them elastically. Install
compensators if necessary.
 If the pump leaks, the unit may not be operated and must be
disconnected from the mains power supply.
2.9.2 Dry running
If run dry, mechanical seals and synthetic parts can be destroyed
within only a few seconds.
 Do not allow the pump to run dry. This also applies to
checking the rotation direction.
 Purge air from pump and suction line prior to start-up.
12 EN 06|2020