Hauff-Technik MIS 60-ND Instructions D'installation page 35

MIS 60-ND
Insert the adapter for the tubular guide elbow into the
1
wall entry pipe on the inside of the building so that it is
fl ush with the wall (see fi g.: 26).
Then push the tubular guide elbow into the adapter as far
2
as it will go (see fi g.: 27).
Keeping the tubular guide elbow straight, feed the micro-
pipes/cables through it.
NOTE!
Failure to seal due to incorrect installation!
Improper installation can result in damage..
• The minimum bending radiuses of the glass fi bre
cables and micropipes must be observed!
Turn the tubular guide elbow to face the desired direction
3
and then bend it until the whole of the guide elbow has
snapped into position (see fi g.: 28).
Service telephone +49 7322 1333-0
Art. Nr.: 5090032017 Rev.: 00/2018-07-31
EN
Fig.: 26
Fig.: 27
Fig.: 28
Subject to change.
35