Hauff-Technik MIS 60-ND Instructions D'installation page 31

MIS 60-ND
Then insert the wall entry pipe into the drilled hole until
9
the outer fl ange is outside the outer surface of the wall
(see fi g.: 11 and 12).
Make sure that the resin fi ller hose is at the top (see fi g.:
11).
Legend for fi g.: 11
1 Resin fi ller hose
Guide the unclamped quick tensioning device onto the
10
MIS wall entry pipe. The resin fi ller hose will be guided
at the top into the opening (see fi g.: 13).
Legend for fi g.: 13
1 Quick tensioning device MIS 60-SVS
2 Resin fi ller hose
3 Mark (Wall thicknesses X + 30 mm)
Then insert the socket of the quick tensioning device
into the drill hole (see fi g.: 14).
NOTE!
Failure to seal due to incorrect installation!
Improper installation can result in damage.
• The marking showing the wall thickness must
still be visible (see fi g.: 14)!
Then secure the quick tensioning device by tightening
the vertical screw (see fi g.: 14).
Legend for fi g.: 14
1 Vertical screw
► The wall entry pipe is now fi xed!
Art. Nr.: 5090032017 Rev.: 00/2018-07-31
1
3
1
2
1
EN
Fig.: 11
Fig.: 12
Fig.: 13
Fig.: 14
31