Niko 10-364 Information De Produit page 69

A transponder has a unique number, which can be assigned to one or multiple transponder reader(s). This number is saved in the transponder
reader. A transponder (or master transponder) can be programmed on multiple devices.
• When entered correctly, a positive confirmation tone sounds
If the input of a command series
confirmation tone sounds.
• If a command series is incompatible with the requested syntax or if too many parameters are entered, the entire command series is
cancelled and a negative confirmation tone sounds.
• When operating the infrared remote control, aim the front towards the external unit as much as possible. The infrared remote control has a
direct reach range of max. 1 m.
• Each push on a key of the infrared remote control is confirmed by a short key confirmation tone
10. CONTROL
The electronic key must be moved along the device at a maximum distance of 20 mm.
• the LED lights up green
• upon reading a key, a simple, positive confirmation tone sounds
• activation of the door opening contact
• If a negative confirmation tone sounds 3 times, no access is granted.
• After 3 failed attempts, the device is blocked for 2 min.
11. INFRARED REMOTE CONTROL
11.1. Starting the device
Remove the plate at the back of the infrared remote control of the battery.
Remove the tabs.
Place back the plate.
11.2. Replace battery
For the infrared remote control, 1 key cell battery CR2025 (DC 3.0 V) is needed.
Remove the plate at the back of the infrared remote control of the battery.
Please note the polarity of the battery and the "+/-" markings in the battery compartment.
Place the battery.
Place back the plate.
12. ACCESSORIES
Short description
Transponder key
Transponder card
EN
is interrupted during 8 seconds, the entire series is cancelled. A negative
Reference
10-905-01
10-905-02
.
Image 7: Control
10-364
.
69