Publicité
Les langues disponibles
Les langues disponibles
10-364
9.3. Remove all transponders
Start the programming
Briefly hold the master transponder
in front of the device three times.
possibility of removal
Hold master transponder in front of
device again
all transponders removed
time to remove has been exceeded
(8 s)
9.4. Terminate programming
Briefly hold the master transponder
in front of the device three times.
programming mode terminated
Or: wait
programming mode terminated
68
if not already done
• briefly hold master transponder in front of device three times
• a positive confirmation tone sounds and LED briefly flashes green
There can only 3 sec. between two
actions, otherwise the device will
terminate the programming mode.
• LED flashes red during 3 sec.
• Briefly hold master transponder in front of the device again as
long as LED is still flashing red.
• a positive confirmation tone sounds,
• LED flashes green again.
• The device reverts to programming mode.
• briefly hold master transponder in front of device three times
• a positive confirmation tone sounds and LED flashes green again
• a positive confirmation tone sounds
• LED lights up green during 3 sec
• LED off again
Or:
• no programming for 2 min
• a positive confirmation tone sounds
• LED lights up green during 3 sec.
• LED off again
G
R
G
G
G
G
EN
Publicité
