Publicité
Les langues disponibles
Les langues disponibles
10-364
8.4.9. Change master code
For safety reasons the preset master code must be changed when put into service!
Start the programming
Enter the following key
combination on the infrared remote
control.
Change master code
wrong code, master code unknown
8.4.10. Terminate programming
Start the programming
Enter the following key combination
on the infrared remote control.
or
wait
terminated
9. PROGRAMMING WITH MASTER TRANSPONDER
• The transponders (cards or key) must be moved along the device at a maximum distance of 20 mm.
• If the input of a command series is interrupted during 8 seconds, the entire series is cancelled. A negative confirmation tone sounds.
9.1. Terminate programming
Authorisation with
master transponder
66
if not already done
* 98 # old master code #new master code # new
master code #
Mastercode = 6 digits
• LED lights up green during 3 sec.
• a positive confirmation tone sounds
• LED flashes green again
• a negative confirmation tone sounds
• LED lights up red during 3 sec.
• LED flashes green again
if not already done
9
• LED off
or
• no programming for 2 min
• A positive confirmation tone sounds
• LED lights up green during 3 sec.
• LED off again
The external unit remains available for
programming for another 5 min. No need to
restart the programming.
G
G
R
G
G
EN
Publicité
