Niko 10-364 Information De Produit page 62

10-364
and off again
Authorisation via
infrared remote control
Enter the master code.
correct code:
programming possible
wrong code, master code unknown
no code entered
8.4.2. Programming transponder
Start the programming
Enter the following key
combination on the infrared remote
control.
hold transponder in front of device
program other transponders
only 1 memory location available
all 50 memory locations have been
assigned
62
Press the RUN/PROG key briefly. The green LED will light up.
RUN
PROG
* Master code #
(FI = <6-digit serial number of the transponder reader>)
With each push on the key, the device
sounds a short key confirmation tone.
• a positive confirmation tone sounds
• LED lights up green during 3 sec.
• LED flashes green
If you press #, a negative confirmation tone sounds.
After 3 wrong codes, the code entering
function will be blocked for 2 minutes.
• LED lights up red during 3 sec., after flashes green again
• LED lights up red during 2 min, after flashes green again
Start again.
After 2 min, the devices automatically
terminates the programming mode. The
LED will also switch off.
if not already done
* 0 # MlNo #
MlNo = number of the memory location 0 to 49
Hold the transponder to be programmed in front of the device.
• LED lights up green during 3 sec.
• a positive confirmation tone sounds, LED flashes green again.
• the transponder has been programmed
Repeat the steps.
• LED flashes orange
• LED lights up orange
G
G
R
G
G
G
O
O
EN