Niko 10-364 Information De Produit page 60

10-364
7.2. Factory settings
ExtU address for door opening function
Relay switching time
Programming lock
Switch relay contact upon receipt of the door opening protocol
Programming mode can only activated on power supply and control unit
Audio signal
Free protocols 1 to 4
Master code
Master transponder code
RS485 activated
Bus connected
7.3. Configuration options
Operation
Programming transponder
Remove transponder
Set ExtU address
Set relay switch time
Load factory settings
Programming master transponder
Change master code
Activate programming lock
Free protocols 1 to 4
Programming with service unit 10-870 is not possible.
8. PROGRAMMING
8.1. Initial activation
For the initial activation you will need the infrared remote control.
As authorisation, enter the 6-digit serial number of the transponder reader.
Select a transponder as master transponder. Hold a transponder in front of the external unit and add labelling. Other transponders will be programmed using
the master transponder.
Terminate programming.
For safety reasons the preset master code must be changed when put into service!
60
Infrared remote control
x
(up to 50)
x
(remove separately)
number of memory location must be known
x
(remove all at once)
x
x
x
x
x
-
-
0
approx. 3 sec.
OFF (= 0)
ON (= 1)
ON (= 1)
ON (= 1)
00000000 (16 bit)
Serial number of the device
00000000 (no master transponder)
ON (= 1)
yes
Master transponder
x
(up to 10)
-
x
(remove all at once)
-
-
-
-
-
-
-
Niko Configuration SW
x
(up to 250)
x
x
x
x
x
x
x
x
x
EN