Niko 10-364 Information De Produit page 64

10-364
8.4.5. Set switching time for R-contac
Start the programming
Enter the following key
combination on the infrared remote
control.
switching time set
invalid value entered
8.4.6. Set ExtU address
Start the programming
Enter the following key
combination on the infrared remote
control.
ExtU address set
invalid value entered
8.4.7. Set master transponder
Start the programming
Enter the following key
combination on the infrared remote
control.
64
if not already done
* 8 # value #
Value = switching time adjustable in steps of 1s, 0 tot
255 sec.
0 = deactivated, no response
(FI = 3 s)
• LED lights up green during 3 sec.
• a positive confirmation tone sounds
• LED flashes green again
• a negative confirmation tone sounds
• LED lights up red during 3 sec.
• LED flashes green again
if not already done
* 4 # value #
BP address = 0 tot 63
(FI = 0)
• LED lights up green during 3 sec.
• a positive confirmation tone sounds
• LED flashes green again
• a negative confirmation tone sounds
• LED lights up red during 3 sec.
• LED flashes green again
if not already done
* 97 #
G
G
R
G
G
G
R
G
EN