Niko 10-364 Information De Produit page 65

8 seconds
hold transponder in front of device
master transponder saved
exceeded time: transponder is denied
By setting another transponder as the master transponder, the previously programmed transponder is overwritten.
8.4.8. Load factory settings
• The master code is reset to the factory setting.
• The master transponder is removed.
• The set transponders are retained.
Start the programming
Enter the following key
combination on the infrared remote
control.
factory settings loaded
wrong code, master code unknown
EN
The transponder must be held in front of
the device within 8 seconds.
Briefly hold a transponder of your choice in front of the
device once.
• a positive confirmation tone sounds
• LED flashes green again
• a negative confirmation tone sounds
• LED lights up red during 3 sec.
• LED flashes green again
if not already done
• * 99 # master code # master code #
• Master code = 6 digits
• LED lights up green during 3 sec.
• a positive confirmation tone sounds
• LED flashes green again
• a negative confirmation tone sounds
• LED lights up red during 3 sec.
• LED flashes green again
10-364
G
R
G
G
G
R
G
65