Niko 10-364 Information De Produit page 63

transponder is denied:
• memory location already in use or
• transponder already programmed
on another memory location
Number of transponders which can be programmed: up to 50.
8.4.3. Remove transponder
Start the programming
Enter the following key
combination on the infrared remote
control.
remove assigned memory location
assigned memory location removed
memory location is not assigned
8.4.4. Remove all transponders
Start the programming
Enter the following key
combination on the infrared remote
control.
all transponders removed
Number of transponders which can be removed: up to 50.
EN
When holding the transponder in front of the device, a negative
confirmation tone sounds.
• LED lights up red during 3 sec.
• LED flashes green again
Either delete the assigned memory
location or the transponder on the
incorrectly programmed memory
location.
if not already done
* 3 # MlNo #
MlNo = number of the memory location 0 to 49
• LED lights up green during 3 sec.
• a positive confirmation tone sounds
• LED flashes green again
• LED lights up red during 3 sec.
• a negative confirmation tone sounds
• LED flashes green again
if not already done
* 94 # master code # master code #
Master code = max 6 digits
• LED lights up green during 3 sec.
• a positive confirmation tone sounds
• LED flashes green again
10-364
R
R
G
G
R
G
G
G
63