Niko 10-364 Information De Produit page 67

Hold master transponder in front
of device
Master transponder
recognized: programming possible
Wrong, unknown master
transponder
9.2. Programming transponder
Start the programming
all memory locations empty
hold transponder in front of device
the transponder has been
programmed
program other transponders
only 1 memory location available
all 10 memory locations have been
assigned
transponder is denied:
memory location already in use or
transponder already programmed
on another memory location
Number of transponders which can be programmed: up to 10.
EN
• Hold master transponder in front of device.
• a positive confirmation tone sounds
• LED lights up green during 3 sec.
• When holding the transponder in front of the device, a negative
confirmation tone sounds.
• LED lights up red during 3 sec.
• LED off again
• If the master transponder is held in front
of the device incorrectly 3 times, the code
entering function is blocked for 2 min.
• The LED lights up red for 2 min.
• Start again.
if not already done
The number of the transponder will be registered in the next free
memory location.
MlNo = number of the memory location 00 to 09
Briefly hold the transponder in front of the device once.
• a positive confirmation tone sounds
• LED lights up green during 3 sec.
• LED flashes green again
Repeat the steps.
• LED flashes orange
• LED lights up orange
• When holding the transponder in front of the device, a negative
confirmation tone sounds.
• LED lights up red during 3 sec.
• LED flashes green again
First delete the memory location.
10-364
G
R
G
G
O
O
R
G
67