RIB SUPER 6000 Mode D'emploi page 29

A - CONNEXIONs
IT Is COMPULsOrY TO
sET THE DIP 13 Of THE
CONTrOL PANEL IN THE
ON POsITION.
T1
T2
JA
T T R S T N
3-PHASE LINE
400V + N
L1 - N 230Vac 50/60Hz POWER SUPPLY (TO BE DONE BY THE
J1
MANUFACTURER)
BLINKER (40 W MAX.)
U CONNECTION TO T1 AND T2 POWER RELAYS
J2
V-W
PED. BUTT. PEDESTRIAN OPENING CONTACT (NO)
J3
A+ TEST +24Vdc SAFETY STRIP SELF-TEST POWER SUPPLY
LSC CLOSE LIMIT SWITCH THAT CUTS OFF THE MOTOR IN
CLOSING
COM LIMIT SWITCH COMMON CONTACT
LSO OPEN LIMIT SWITCH THAT CUTS OFF THE MOTOR IN
OPENING
STOP STOP CONTACT (NC)
J4
OPEN OPENING CONTACT (NC)
CLOSE CLOSING CONTACT (NC)
K. BUTT. SINGLE PULSE CONTACT (NO)
A+ ACCESSORIES POWER SUPPLY +24Vdc
A- ACCESSORIES POWER SUPPLY -24Vdc
SIGNAL GATE OPEN INDICATOR 24Vdc
COM COMMON CONTACT (common line for all the command
and safety inputs)
EDGE NC SAFETY STRIP CONTACT (NC)
AERIAL RADIO ANTENNA
J5
COM COMMON CONTACT (common line for all the command
and safety inputs)
PHOTO NC PHOTOCELLS CONTACT (NC)
PROBE IS NOT AVAILABLE
J6
s3
J5
Tr1
Tr2
J4
J3
sW s1
J2
U V W
J1
MOTOR
3 P
PTO
J7 J6
sW1
sW2
sW3
ENCODER IS NOT AVAILABLE
J7
RADIO CONNECTOR FOR EXTERNAL RADIO RECEIVER 24Vdc
J8
PROG. PROGRAMMING BUTTON
s3
LOW SPEED IS NOT AVAILABLE
Tr1
IS NOT AVAILABLE
Tr2 TORQUE
SW S1 DO NOT rEMOVE THE JUMPEr!
sW s1
OTHErWIsE THE OPErATOr WILL NOT WOrK!
DIP-SWITCHES
sW1
sW2
sW3
POWER RELAYS FOR THE COMMAND OF THE MOTOR
T1 - T2
TT MOTOR THERMAL CONTACT
JA
R-S-T THREE-PHASE POWER SUPPLY
N NEUTRAL
CONTACTS FOR THE EARTH CONECTION
U-V-W MOTOR CONNECTION
NC: NORMALLY CLOSED CONTACT
NO: NORMALLY OPEN CONTACT
29 29
29
29
I
NNEr THErMAL OVErLOAD
CUT-OUT sWITCHEs (per CEI
2-3/IEC 34-1)
The electrical protections on the
SUPER 6000 motor power line may
not be sufficient to protect against
overloads. If the cooling conditions
J8 worsen, the motor overheats but the
electrical conditions do not change,
which inhibits line
Installing
bimetallic
PTO on the s1/r4
control panel solves
this problem.
This is a normally-
closed electromechanical device that
opens when the threshold temperature
is reached; it automatically resets
when the temperature falls below the
threshold level.
T
G
B
protections.
the
device
T