RIB SUPER 6000 Mode D'emploi page 27

M
OTOr AND rACK INsTALLATION
SUPER 6000 has a plate to be cemented to the ground and is locked
in place by the four supplied 14x45 hex bolts using a N° 22 setscrew
wrench.
The rack must be fixed at a certain height with respect to the motor
base.
This height can be varied thanks to the slots on the rack.
The rack must not be welded, but simply fixed to the gate with threaded
screws.
The height needs to be adjusted so that the gate does not rest on the
reduction unit traction gear (Fig. 5,6).
Holes with a diameter of 7 mm should be made to fix the rack into the
gate, and they should be threaded using a M8 type screw tap.
The pinion must have a clearance of 1 to 2 mm with respect to the rack.
L
IMIT sWITCH ADJUsTMENT
SUPER 6000 has two independent watertight limit switches mounted on
the reduction gear. These are able to stop the gate from moving.
H
YDrAULIC CLUTCH ADJUsTMENT
Unscrew plug A, remove three-quarters of the oil in the hydraulic
clutch, then re-tighten the plug. Now gradually add small amounts of
the removed oil through the hole of plug B until the gate starts to move
at a progressive speed (it must reach normal running speed within 2
seconds).
CLUTCH MAINTENANCE
Change the oil for the first time after 2 months service and once a year
from then on.
rECOMMENDED TYPEs Of OIL:
AGIP OSO 35 / SHELL TELLUS OIL 29 / FINA HEDRAN 31 ( BP
ENERGOL HL 65 / TERESSO 43 / ARAL E100 EXTRA / MOBIL ATF
2000 / CHEVRON OC TURBINE OIL 11 / GULF PARAMOUNT 35
A
DJUsTING THE V-BELTs
SUPER 6000 has two V-belts that transmit power from the motor-clutch
unit to the reduction gear. These two belts are adjustable and their
tension can be varied by shifting the motor-clutch unit in height.
To do this, use a N° 22 wrench to release the four bolts that fix the
motor to the slideways. Now use a N° 17 wrench to turn the screw
between the reduction gear and motor clockwise to slacken the belts, or
anticlockwise to tighten them.
NOTE: It is absolutely essential to comply with this procedure to prevent
the reduction gear from being excessively stressed by kick-back from
the gate when starting, stopping and reversing (the part should be
replaced every 2 years).
NOTE: The V-belts will have already been adjusted when SUPER 6000
is supplied.
M
AINTENANCE
To be undertaken only by specialized staff after disconnecting
power supply.
Clean the sliding guide of stones and dirt periodically only when the gate
does not move.
ALWAYs UsE AN OPEN/CLOsE PUsH BUTTON WHICH
Is DEsIGNED TO PrEVENT THE POssIBILITY Of
sIMULTANEOUsLY sENDING THE OPPOsITE COMMAND
Of OPENING AND CLOsING AND AVOID sO A DAMAGE
TO THE MOTOr.
0,8"
Measurements in mm/inch
27
27
11,4"
8,2"
7,2"
G
B
5
6
7