GRAUPNER Alpina5001 PRO Mode D'emploi page 43

4 Multilick Socket
2 Piano wire
2 Bell-crank assembly
1 GRP leaf spring
6 Incidence pins
2 Brass tubes
2 Self tapping screw
1 Piano wire
1 Canopy spring
5 Velcro tape
2 Velcro tape
1 Winch hook
Servolock Set
6 (8*) Servo frame
3(4*) Servo covers/Left
3(4*) Servo covers/Right
24(32*) Self tapping screw
1 Instruction sheet
* 8 servo wing version only
Note: Contents and technical details subject to change without notice.
Graupner GmbH & Co. KG, Henriettenstraße 94-96, 73230 Kirchheim
43
Wing retainer
Elevator joiner
Elevator
Canopy
Wing panels
Wing tip joiner
Battery mount
Canopy pin
Canopy retainer
Canopy / Receiver
Battery retainer
Glider only
Wings
Wings
Wings
Wings
www.graupner.de * www.tangent-modelltechnik.com
Nylon Ready made
Spring steel D3 * 140
See instructions Pre-installed
GRP Ready made
Steel 3 * 60 (50)
Brass 4 * 0,5 * 50
Steel 2.2 * 13
Spring Steel 3 * 30
CSF 1.5 * 15* 150
Hook & Loop 30 * 60
Hook & Loop 30 * 60
Ready made
Milled plywood
Plastic Ready made
Plastic Ready made
Steel M 2 * 10
Paper A5