Fitting The Blade Guard And Saw Blade; Fitting The Trimmer Guard And Trimmer Head Trimmy Sii - Jonsered FC2245 Manuel D'utilisation

disk. Hold the shaft of the socket spanner as close to
the blade guard/combination guard as possible.
WARNING! Tighten the lock screw (N) in
!
the center hole of the support cup.
Tighten to a torque of 35-50 Nm (3.5-5.0
kpm), CAUTION! Left-hand thread. If the
lock screw is not fitted in the support
cup, there is a risk that the support cup
will come unscrewed. This means that
the blade will also come loose, which
could result in serious or fatal injury to
the operator or others.
Fitting the blade guard and saw
blade
• The blade guard (A) is fitted using 4 screws (L) as
shown.
CAUTION! Always use the recommended guard for the
cutting attachment you are using. See chapter on
Technical data.
• Fit the drive disc (B) on the output shaft.
• Turn the blade shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
• Insert the locking pin (C) in the hole to lock the shaft.
L
A
ASSEMBLY
• Place the blade (D) and support flange (F) on the
output shaft.
G
B
• Fit the nut (G). The nut must be tightened to a torque
of 35-50 Nm (3.5-5 kpm). Use the socket spanner in
the tool kit. Hold the shaft of the spanner as close to
the blade guard as possible. To tighten the nut, turn
the spanner in the opposite direction to the direction
of rotation (Caution! left-hand thread).
When loosening and tightening the saw blade nut, there
is a risk of injury from the teeth of the saw blade. You
should therefore always ensure that your hand is shielded
by the blade guard when doing this. Always use a socket
spanner with a shaft that is long enough to allow this. The
arrow in the diagram shows the area where you should
operate the socket spanner when loosening or tightening
the nut.
Fitting the trimmer guard and
trimmer head Trimmy SII
• Fit the correct trimmer guard (A) for use with the
trimmer head. Hang the trimmer guard/combination
guard (A) on the two hooks on the plate holder (M).
Bend the guard around the shaft and tighten it with the
bolt (L) on the opposite side of the shaft. Use the
F
D
C
–
English 51